Mounting the Instrument Figure, Pressure Connection | GE RPT 301

4	RPT 301 User Manual

2 Installation

Installation must be carried out by a qualified technician.

2.1Mounting the Instrument (Figure 2.1)

The instrument can be mounted on a vertical surface using two screws or bolts to a maximum diameter of 4 mm.

Figure 2-1 Mounting Arrangement

2.2Pressure Connection

The pressure port is a G1/8. If a pipe is connected to this port a bonded seal must be used. The instrument is very sensitive to air movement (small local pressure changes), when the pressure port is directly sensing the atmosphere, the fitting of a filter or restrictor is recommended.

K177 Issue No. 3

Image 12

GE RPT 301 user manual Mounting the Instrument Figure, Pressure Connection

Contents

RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Specification DimensionsDescription Accuracy Power supply Pressure measurementData Communications Pressure connection Accessories Mounting the Instrument Figure Pressure Connection Instrument Dimensions Electrical Connection Communication connections Connections for remote on/off control Communications Changing the communication interface standard Figure LK1 LK2 PL3PL1 RPT Screening Command Summary System Operation Command Function Measurement CR Crlf Command TerminatorsSet-up User calibration General Command Format Single commandsCommand Strings Page Error Message General Reply Format Data out of range Detailed Command Definitions Measurement Commands Return stored readingGet reading Auto send reading Auto Send from switch-on Set-up Commands Unit Set-up Command F, step, average Set ResolutionFilter Set-up Set Communications Options Command I,S/PIN, Name ValueCR format StatusIdentity Calibration Check User Calibration Linearity/Drift Compensation PIN Change PIN PIN, New PIN LED Indicator Diagnostic ModeDiagnostic Mode General Cleaning Approved Service Agents