GE superbus 2000 concord 4 gsm module installation instructions Introduction, GSM status LEDs

SuperBus 2000 Concord 4 GSM Module

Installation Instructions

466-2262A • October 2006

Copyright © 2006, GE Security Inc.

Introduction Installation tips

This is the GE SuperBus 2000 Concord 4 GSM Module Installa- tion Instructions for part number 600-1053. The module can be used on Concord 4.0 and higher.

The module interfaces with the Concord panel data bus and is powered by the panel battery or an auxiliary 12 VDC power supply. Status LEDs indicate bus and paging network communi- cations. A supervised zone input allows you to connect a hard- wired contact. Figure 1 shows the location of the main module components and Table 1 describes the component functions.

Use the following tips to help guarantee your success with the Alarm.com Concord GSM Module:

1.	Make sure you create the customer account on the
	Alarm.com dealer website at least 24 hours before installa-
	tion. See Account creation on page 6.
2.	Make sure you turn off the Access Code Lock feature.
3.	Use the LEDs on the module to check the signal strength
	before you permanently mount the module.
4.	Power the module off of the battery (see Wiring on page 3),
	not off of the panel.

Figure 1. Main module components

PWR LED

BUS LED

AUTO LED

Unused LED

Status LEDs

Wiring terminals

Antenna

jack

SIM

card

Serial

number

label

GSM

status

LEDs

5. Do a manual phone test to initiate communication (see

Power up on page 4).

GSM status LEDs

Figure 2 shows the GSM status LEDs and Table 2 describes the LED functions. See GSM status LEDs on page 5 for more infor- mation.

Figure 2. GSM status LEDs

Serial number label

		L1	L2	L3	L4
			GSM status LEDs
Table 2.	GSM status LEDs

Table 1.	Module component descriptions
Component		Function
PWR LED		Indicates module power status.
BUS LED		Indicates data bus activity between the panel and
		module.
AUTO LED		Indicates module/data transceiver communication.
Status LEDs		Indicates communications status with GSM network.
Wiring terminals		Provides panel and zone wiring connections.
Antenna jack		Antenna connection for wireless data transceiver.
GSM status LEDs		Indicates communication with the GSM network,
		report errors, and signal strength.
Serial number		A 15-digit number beginning with 35323900. Only the
		last 10 digits, starting with 900, are used for account
		activation.

LED	Function
LED 1	Error LED. Will slash 1 to 8 times in a four-second
	interval to indicate specific error conditions such as a
	network error, panel communication error, or GSM
	radio error.
LED 2	Panel communication LED. Flashes every time a data
	packet is received from the panel.
LED 3	GSM communication LED. Flashes every time a data
	packet is received from the GSM radio.
LED 4	GSM signal level LED. Flashes 0 to 5 times, or toggles
	on/off when communicating with the Alarm.com
	servers.