DrawersCmw”s
(continued)
The drawer cover support assembly consistsof a post, a sleeveand a foot. The sleeveand post haveadjustment teeth which, when engaged,lock them together;and when disengaged, allow the sleeveto move up and down freely in the post.
The support assemblyis adjusted at the factory. To readjustit, if necessary:
1. Make sure the support assembly |
is firmly attached to the drawer |
cover (see page 9) and the drawer |
cover is in place in the cabinet. |
2. Make sure the adjustmentteeth |
are disengaged. (If engaged, rotate |
the sleeve 1/4turn counterclockwise |
Meat
rnodek equipped)
I
Fresh meats are storedbest in
the coldest part of the refrigerator.
When this draweris placed in the top 6 slots on the left side and the lever is set at COLDEST, air from the freezer is forced around the drawer to keep it very cold.
Youcan movethe drawer to any location for storage of items other than fresh meats.
W@pped)
If your refrigeratoris operated before waterconnection is made to the icemaker, keep the icemaker feeler arm in the OFF (up) position
as shownbelow. | Feeler Arm in |
W .
to disengagethem.) With the foot of |
the support assembly resting on the |
cabinet floor and the sides of the |
cover resting on the ledges on the |
cabinet’sside walls, turn the sleeve |
1/4turn clockwise |
teeth. Note: If teeth do not mesh, |
move the sleeve up slightly as you |
turn it. Do not raisethe drawercover. |
To reinstall the |
|
|
foot ifit comes |
| u — |
off, guide the pins |
| |
on the foot into the |
| t. |
slots at the bottom |
| |
of the sleeve. Then | * | /’ |
rotate the foot | D |
|
clockwise until the |
|
|
pins snap firmly |
|
|
into place. |
|
|
The variable t control lever lets you regulate the amount of cold air surrounding the drawer.
When the kver i all the way up, the damper over the opening in the drawer is fully open to provide the coldest storage area.
when. the kver is a t way down, the damper is fully closed. Normal refrigerator temperatures will be maintained.
Variable settings between these extremes may be selected.
SBin
When r | has b~~~ |
connected t | water supply? move |
the feeler arm to the ON (down) | |
position. | Feeler Arm in |
| ON position |
Ice cube mold will automatically fill with water after cooling to freezing temperature, and first cubes will normally freeze after several hours. When cubes are solidly frozen, they will be ejected from the mold into the ice storage bin by means of a sweeper arm.
‘$f%xw
—
:. :...
,L,:.” ~ .. ~.
.
!:..,. [“ : f; : ~,;
~:;.
10
