GE TBX17, TBXW19, TBX19 manual Tilt and removethe glass cover

[11

l

/

3.Reach in, push the front of the glass cover up and, at the same time, pull it forward until it clears the frame at the back.

4.Tilt and removethe glass cover.

To removethe drawers,lift front up		-------------,
slightlyand puHthe drawerstraight
out.	[

2.Put the drawer slides back on the frame. ‘I’hesloped ends must beat the front.

To removethe cover,support it	... .-
with one hand, tilt it and take it out.
	-. ...

5.Removethe 3 drawer slides.

6.Removethe drawer frame as foJlows:

~Lift the front of the frame to free it from the supports at each side.

~Lift the rear of the frame to free its hooks from the tracks on the back wall of the refrigerator.

QTilt the frame and take it out.

‘h replace:

1.Fit the hooks on the drawer frame into the second-from-the- bottorn slots on the tracks at the rear of the refrigerator and lower the front of the frame until it locks into position and rests on the front supports at each side.

/’-’%

—1.

~

..-.-”

3.Slide the center and right drawer slides towardthe middle and slide the l/3-width drawer all the way into them.

4.Slide the l/3-width drawer all the wayto the right.

5.Mount the 2/3-width drawer onto the center and left slides.

,~. Replace the glass cover, pushing lts rear edge firmly into the rear frame channel and gently lowering the front into place.

SJ

A

1

~.

-

If the cover suPPortat front center, (on models so”~quipped)becomes separated from the drawer cover, reinstallthe supportbeforereturning the cover to the cabinet.

,-

To ‘ffeinst.d - Wwer support,

turn the cover and support upside down and guide the pins on the support into the hooks on the cover as shown. Then push firmly until the pins lock into place.

pqy)

9