Operation
Reset the Monitor Settings
1.Press and hold the PWR button for at least 1 second.
2.Press the SEL button.
3.Select the Navigation system by pressing the DN or UP button.
:Standard - Navigation for all others (except Europe)
:Europe - Navigation for Europe only
If no key is pressed within 10 seconds, the
Adjustment
1.Press and hold the SEL button for at least 1 second.
2.Each press of the button will cycle through the modes as follows:
BRIGHT
COLOR
TINT
DIMMER
DIM. LEVEL
MONITOR
MIRROR 
3. Adjust by pressing the DN or UP button.
¥BRIGHT: Allows the brightness of the picture.
¥COLOR: Change the color balance of the picture.
Note: It is not adjustable in NAVIGATION (RGB connection) mode.
¥ TINT: Adjust the tint of the picture.
Note: It is not adjustable in NAVIGATION (RGB connection) and PAL mode. ¥ DIMMER:
AUTO: Display illumination will dim when while the carÕs parking lights are on.
LOW: Backlighting is set to the adjusted DIM.LEVEL.
HIGH: Backlighting is set to its maximum level.
¥DIM.LEVEL: Adjust the backlighting level for LOW DIMMER.
¥MIRROR: Switch the picture to NORMAL/MIRROR (for rear view camera) image.
4.After completing adjustments, press and hold the SEL button for at least 1 second. If no key is pressed within 10 seconds, the OSD will turn off and any changes made are automatically set.
Notes:
¥After turning the system off, a slight ghost of the image will remain temporarily. This is an effect peculiar to LCD technology and is normal.
¥Under cold temperature conditions, the screen may lose contrast temporarily. After a short
¥The LCD panel is manufactured using an extremely high precision manufacturing technology. Its effective pixel ratio is over 99.99%. This means that there is a possibility that 0.01% of the pixels could be either always ON or OFF.
Page 5
