CARE AND CLEANING OF REFRIGERATOR
(1)REFRIGERATOR INTERIOR
Parts that can be removed should be washed. Dry parts before |
|
returning. Use a small amount of mild detergent if needed. |
|
(Detergent should be wiped clean.) | MILD DETERGENT |
avoid damaging paint or plastic. | |
CAUTION: Use mild detergent and warm water to |
|
(2)REFRIGERATOR EXTERIOR
Wipe off whenever exterior surfaces are dirty or wet. Apply suitable wax to the refrigerator exterior several times a year.
(3)DOOR GASKET
The door gasket will deteriorate quickly if liquid food or juice are spilled on it. Clean the door gasket in the same way as refrigerator interior.
(4)CONDENSER
Diagnosis
Remove front grille when adjusting height of refrigerator or when cleaning the condenser.
1.To remove the grille, hold the bottom of grille and pull forward.
2.To install the grille, hold both ends of grille and push prongs into holes.
Vacuum once or twice a year, since dirt on the condenser will decrease efficiency, increase electricity consumption, and reduce cooling capacity of the refrigerator.
Grille | Grille | |
Grille | Prong | |
Hole | ||
| ||
Condenser |
|
Care, Cleaning & Self-
(5)REPLACING THE LIGHT BULB
FREEZER COMPARTMENT
Remove the lamp cover before replacing the bulb.
NOTE: On some models, a screw must be removed before removing the lamp cover.
REFRIGERATOR COMPARTMENT (upper light bulb) | |||||
1. Pull out the 2 knobs |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| |
or dials. |
| A B C D E |
| OFF 1 3 5 7 9 | |
| Freezer Control | is Initial Setting | |||
|
| ||||
|
| EC is Coldest | |||
2. Remove cover by turning it upward or by pulling it outward.
3.Turn lamp to the left to remove and replace it.
4.Use only a 40W bulb.
32
