Operation
OPERATION OF THE CUSTOM DISPENSER (continued)
(3)OPERATION OF ICEMAKER (AUTOMATIC ICE-MAKING APPARATUS)
GE Icemaker (automatic |
|
require manual water supply. Following completion of |
|
installation of the water supply piping system, lower the |
|
feeler arm switch to “ON.” Ice is now automatically made |
|
and the icemaker will automatically shut off when the bucket |
|
is filled with set amount of ice. | ON |
| |
| Feeler Arm |
| Switch |
|
|
1. REMOVING THE ICE BUCKET |
|
|
|
1. While holding bottom of the icemaker compartment cover, |
|
gently push upward. |
|
2. Pull forward to remove the icemaker compartment cover |
|
and ice bucket together. |
|
To replace ice bucket, push it straight back until it clicks in | Ice Bucket |
place. If the ice bucket does not seat completely due to an |
|
interference of the rotating wing on the back wall, pivot the |
|
rotating wing by hand approximately 1/3 turn and retry. |
|
Wing
2. CLEANING THE CUSTOM DISPENSER |
|
|
|
Any spilled ice or water will evaporate naturally from the |
|
bottom of the custom dispenser. If juice or other liquid is | Recess |
spilled, however, residues will remain even if the water has | Cover |
evaporated. Remove the recess cover and wipe with a warm, |
|
damp cloth. |
|
21
