GE ZBD1870NSS Dishwasher Wet Test, Replace Toekick, Literature, Installation Instructions

Models: ZBD1870NSS

1 14
Download 14 pages 10.95 Kb
Page 14
Image 14
STEP 16 DISHWASHER WET TEST

Installation Instructions

STEP 16 DISHWASHER WET TEST

STEP 17 REPLACE TOEKICK Turn on power supply (or plug power cord into outlet, if equipped).

STEP 18 LITERATURE Start the unit to check for leaks.

Press ON/OFF button to turn unit on

Press CYCLE SELECT button until light below RINSE cycle illuminates

Manual background Close door.

Manual background Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on.

Manual background Check for leaks under the dishwasher. If a leak is found, turn off power supply, then tighten connections. Restore power after leak is corrected.

Manual background Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinet. Reposition the dishwasher if necessary. See Step 9.

Manual background The dishwasher will drain and turn off about 5 to 7 minutes after the first fill. Check drain lines. If leaks are found, turn power off at the breaker and correct plumbing as necessary. Restore power after corrections are made. See Step 12.

Manual background Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged. See Step 13. Also check drain line for kinking.

Manual background Run the dishwasher through another fill and drain cycle. Check for leaks and correct if required.

Manual background At the end of drain, open door and press ON/OFF button to turn unit off.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

GE Consumer & Industrial

General Electric Company

Louisville, Kentucky 40225

monogram .com

STEP 17 REPLACE TOEKICK

Use Top 4

Screw Holes

2-

Toekic

k

 

Adjust Up or Down

Figure KK

Place 2-piece toekick against the legs of the dishwasher.

Place the inner toekick piece (with slots) against the toekick bracket. The slots should align with toekick bracket screw holes. Allow the toekick to touch the floor.

Place larger toekick over the inner piece and install 4 toekick screws.

Use additional 2 screws for installations over 33-1/2" high.

Use both toekick pieces for all installation heights.

STEP 18 LITERATURE

Be sure to leave complete literature package and Installation Instructions with the consumer.

© 2005 General Electric Company

Pub. No. 31-30243

Dwg. No 206C 1559 P 18 1

ND 08C 251 5 (4/08)

Page 14
Image 14
GE ZBD1870NSS installation instructions Dishwasher Wet Test, Replace Toekick, Literature, Installation Instructions