Design Guide
FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES
THE INSTALLATION SPACE
PRODUCT CLEARANCES
IMPORTANT:
When installed in a corner:
Countertop |
Locate
Outlet
24"
NOTE: Handles not supplied.*
Clearance for Door
Opening
Allow
NOTE: Custom handle clearances may vary depending on the standoff of the custom handles.
• Test the drawer openings. Carefully open and close |
the drawers. The drawers should not rub or catch on |
adjacent cabinetry. Notify the installer if the drawers |
*Custom handle clearances may vary, depending on the standoff of the custom handles.
The cutout depth should be 24″
The cutout dimensions shown allow for full drawer extension.
NOTE: The drawers should be flush with the surrounding cabinets.
Additional Specifications
•A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded
make contact with cabinetry. NOTE: When installing |
custom panels and handles, use above clearances as |
a general guide but adjust according to the installation. |
Choose the location:
•These products may be closed in on the top and three sides as long as the front is unobstructed for air circulation and proper access to the drawers.
•Do not install these products where the temperature will go below 55°F (13°C) or above 90°F (32°C).
•These products are not designed to be stacked one over the other
Black or Stainless Steel Toekick Options
•These products are shipped with two toekicks,
a stainless steel and a black toekick. For shipping purposes, one of the toekicks will be secured to the back of the unit and the second will be installed, in place, on the unit. Keep the unused toekick, and other unused or removed parts, for future use.
Custom Panel Models Only
For a complete refreshment center, install a
•A
•Products must operate from separate, properly grounded receptacles.
| Locate | |
| Outlet | |
| ||
9" | 9" | |
| 15" | |
|
| |
| ||
| *NOTE: Additional clearances | |
| may be required. |
|
5