Installation Instructions
STEP 2 INSTALL CUSTOM 3/4″
DRAWER PANELS AND HANDLES (CONT.)
(ZIDI240 model only)
•Reinstall the side trims using the trim screws removed earlier.
•Place the brushed decorative covers over the side trim to hide the screw heads. Ensure side trim is aligned top to bottom and front to back. Snap into place.
NOTE: For shipping purposes, the brushed decorative cover will be secured to the front of the unit.
STEP 3 LEVEL
Use an adjustable wrench to turn and raise or lower the leveling legs.
•Measure floor to countertop height inside the opening.
Adjust leveling legs until the product is approximately 1/8″ less than countertop height.
Turn Right to Lower
Turn Left to Raise
INSTALLATION TIP:
Measure floor to underside of countertop inside the opening.
•If the room floor is higher than the floor inside the
opening, adjust the rear leveling legs to approximately 1/8″ less than the opening height. Screw front leveling legs all the way in to shorten the height at the front.
This will allow you to slightly tip the unit into the opening. Once the unit is in the correct position, the front legs can be adjusted to level the product.
7
