Installation Instructions
STEP 1 REMOVE PACKAGING
•Remove corner blocks and foam drawer stops.
•Remove all packing material, tape and protective plastic coverings.
CAUTION: Small objects are a choke hazard for children. Remove and discard any parts not used.
ATTENTION : Les petits objets peuvent étrangler les enfants. Il faut jeter toutes les piéces qui ne sont pas utilisées.
STEP 2 INSTALL CUSTOM 3/4″
DRAWER PANELS AND HANDLES
(ZIDI240 model only)
3/4″ Overlay Panel Dimensions
Model ZIDI240 requires
• The overlay panels must be secured
to 1/4″ thick backer panels that Drawer slide into the trims. A .10″ thick
spacer panel must be placed between the overlay and backer panels.
• Custom handles of your choice, supplied by your cabinet maker,
must be installed on these overlay panels. Countersink all screws into the backer panels. Screws cannot protrude from the backer panels.
IMPORTANT NOTE: Maximum total weight for custom drawer panels are 25 pounds
|
|
|
| A |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| 3/4″ Overlay Panel Dimensions (in inches) | |||||
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| A (Width) | B (Height) | ||||||
|
|
| B |
|
| 1/4″ Backer | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 0.10″ Spacer | ||
| * |
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| 3/4″ Overlay | |||||||
|
|
|
|
|
|
|
|
|
| |||||
| B |
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
STEP 2 INSTALL CUSTOM 3/4″
DRAWER PANELS AND HANDLES (CONT.)
(ZIDI240 model only)
Install custom drawer panels and handles:
•Open drawers.
•Remove 2 screws holding each trim; lift trims off. Retain screws.
•Custom handles of your choice, supplied by your cabinet maker, must be installed onto the overlay panels before they are slid into the trims. Countersink all screws into the backer panels. Screws cannot protrude from the backer panels.
Screws Must
Be Countersunk
Into Panel
Handle
Custom 
Drawer Panel
• Slide overlay panels into the trims.
*Maintain a 1/4″ min. gap between top and bottom drawer panels.
Assemble overlay panels with glue and screws.
•Center spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.
Overlay Panel
Spacer Panel
Backer Panel
•Center the spacer/backer panel
on the overlay panel. Secure with glue and screws. Countersink all screws into the backer panel.
6
