GE Monogram Professional Rangetop Before You Begin, Install The Wall Support Panels

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation

ACCESSORIES—30" TO 36" ADJUSTABLE BACKSPLASH (not included)

WARNING:

To prevent ignition of combustible materials, the entire back wall above the range must be protected by a backsplash constructed of non-combustible material.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT: Save these instructions for local inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.

NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.

NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference.

•This backsplash adjusts to fit the space between the top of the range and the bottom of the hood, from 30" Min. to 36" Max. height.

•Maximum shelf load-bearing weight is 40 lbs.

TOOLS AND MATERIALS REQUIRED

•Gloves to protect against sharp edges

•T-15 and #2 Phillips screwdrivers

•	Drill with 3/32" and 9/64" bits		Top Wall
			Support
•	Safety glasses
•	Level	Top Cover
•	Pencil	with Shelf

This Kit Includes

•	Top wall support
•	Bottom wall support	Bottom Cover
• Top cover with shelf
•	Bottom cover	Bottom Wall Support
•	Hardware package with

–9 Stainless Steel Torx 15 #8 self-tapping screws

– 9 Phillips #2 pan head wood #10 screws

– 3 Stainless Steel #2 truss head

Hardware

#10 screws (for alternatePackage installation method)

INSTALL THE WALL SUPPORT PANELS

WARNING: The wall support panels must be securely fastened to the wall. Failure to do so could result in damage or personal injury.

IMPORTANT: This backsplash is designed to cover the wall between the bottom of the hood and the top of the range. The vent hood should be installed over the rangetop or range before installing this backsplash.

•Install and level the Range/Rangetop according to the product installation instructions.

•Remove backsplash packaging and protective film.

•Locate wall studs on each side. Where studs are not available, plan to use wall anchors (not provided).

•Use a level to pencil 2 horizontal lines on the wall,

one 1/8" below the vent hood and the other 1/8" above the Range/Rangetop. This 1/8" space allows the cover panels to overlap the wall supports.

•Secure the top wall support panel to the wall with 4 wood screws, through the outermost studs.

•Use 4 wood screws to secure the bottom wall support panel. The center slot should be positioned at the top.

The gap between the top and bottom support panels will be covered by the top cover with shelf.

	Secure the top
	panel to the wall
1/8″	with 4 wood
	screws

Center	Wood	Secure
Arrow	Screws	the bottom panel
Wood Screws		to the wall with
1/8″		4 wood screws

13