Care and Cleaning
Stainless Steel Outdoor Cooking Center
Burner removal
Ensure the gas supply is off, the knobs are in the OFF position and all surfaces are cool before removing a burner.
The grill and
To remove the grill burner, remove the grill racks, then lift out the lava rock support with the lava rocks still on the support. Grasp the burner, pull it up and slightly to the rear of the unit so the burner head comes off the brass orifice at the front. Angle the burner sideways and remove.
To remove the
The smoker burner can be removed and cleaned by unplugging the igniter wire and lifting out the burner.
To reassemble the burners, replace the burner by sliding the air shutters over the brass orifice, centering it in the hole. It is extremely important
to center the burner on the orifice properly.
Be careful not to upset the air shutters’ original position (unless readjusting). Lower the rear of the burner into the cutouts on the support channel at the rear of the burner box. Make sure it is level and does not rock. Replace the stainless steel radiant tray so that the slots in the corners of the tray align with the projections on the top of the burner. Make sure that it sits level and does not rock.
Light all of the burners and check for proper flame characteristics. (Do not attempt to light the burners prior to replacing radiant trays, grills and aeration pans.) If adjustments are necessary refer to the Installation Instructions.
Flash tubes
Venturi tube
Lighter ports
Igniter
Burner hanger
Air shutters
Grill burner
18