
10.Drive the two screws at the center points about halfway down; first on the latch side, then the hinge side.
11.Continue to tighten the screws a little at a time until fully tightened; no more than 15
Note: You can only pierce the cable once. Once pierced, the KwikLock connector must not be removed. This insures that the inner conductors are not exposed to the elements.
Installing Inside KwikLink Connectors with Blank Caps
Once installed on the grey data cables, these connectors permit you to measure voltage in the system so you can analyze how it is working. The system cannot work properly unless these
1.Lay the cable in the hinged base, noting the correct keyed profile; flat edge toward the hinge, keyed edge toward the latch. Make sure that the cable is properly seated inside.
2.Making sure that the cable is completely straight, carefully close the hinged assembly, and apply firm, even pressure until the first latch locks into place.
Note: Make sure that the flat cable is completely straight before continuing!!
The latch has two catches; the first loosely holds the connector on the cable, the second requires more pressure to close the connector tightly. The cable must be in the correct position for the connector to close properly.
3.Drive the two screws at the center points about halfway down; first on the latch side, then the hinge side.
4.Continue to tighten the screws a little at a time until fully tightened; no more than 15
Note: You can only pierce the cable once. Once pierced, the KwikLock connector must not be removed. This insures that the inner conductors are not exposed to the elements.
The system should now be properly terminated. You can now continue to install components on the system.
Figure 4: Proper Termination Connections
| Standard KwikLink |
Dust Caps | Connectors |
|
Inside KwikLink |
| InsideKwikLink Connector | |
Inside KwikLink Connector |
| ||
with Blank Cap |
| e | Connector |
|
| Cap | |
with Blank Cap |
| with Blank Cap | |
|
|
|
|
ArmorBlock Mounting Plate Kit
ArmorBlock Mounting Plate Kit
PartAEC PNot.NA0556696
7/50D Plus or 7/50D Controller | Chapter 3: Installation | 19 |