Installation Instructions
STEP 2 REMOVE WOOD BASE, INSTALL LEVELING LEGS
IMPORTANT — Do not kick off wood base! Damage will occur.
•Move the dishwasher close to the installation location and lay it on its back.
•Remove the four leveling legs on the underside of the wood base with an adjustable wrench or 15/16" socket.
•Discard base.
Approx.
1/4"
Figure H
•Screw leveling legs back into the dishwasher frame, approximately 1/4" from frame as shown.
STEP 3 REMOVE TOEKICK
•Remove the two toekick screws.
Toekick
Remove 2
Toekick Screws
Figure J
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or has a factory installed power cord.
The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
•Maximum power cord length is 4 feet beyond the back of the dishwasher.
A | B |
|
Insert Power |
| |
Remove |
| |
Cord Wires Thru |
| |
Junction Box |
| |
Cover | Strain Relief |
|
and Tighten |
| |
| White | |
|
|
Ground
Black
C Check That White, Black and |
|
| |
Green Dishwasher Wires Are Threaded | D | ||
Thru Small Hole in Bracket |
| ||
Use UL Listed | |||
| |||
Figure K | Wire Nuts | ||
•Connect incoming power cord white (or ribbed) to dishwasher white, black (or smooth) to black and ground to dishwasher green wire. Use UL listed wire nuts of appropriate size.
•Replace junction box cover. Be sure wires are not pinched under the cover.
STEP 5 INSTALL 90° ELBOW
•Wrap 90° elbow with thread seal tape.
•Install a 90° elbow onto the water valve.
Front of Dishwasher
8
Water Valve
Bracket
90°
Elbow
Fill
Hose
| Thread |
Figure L | Seal Tape |
•Do not overtighten 90° elbow, water valve bracket could bend or water valve fitting could break.
•Position the end of the elbow to face the rear of the dishwasher.
