Before you
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference.
WARNING This appliance must be properly grounded. See “Electrical Supply”, page 6.
For Monogram local service in your area, | Proper installation is the responsibility of the |
installer. Product failure due to improper | |
For Monogram Service in Canada, | installation is not covered under the GE |
Call | Appliance Warranty. See the Owner’s Manual |
For Monogram Parts and Accessories, call | for details. |
| |
If you received a damaged cooktop, you |
|
should contact your dealer. |
|
In the Commonwealth of Massachusetts:
•This product must be installed by a licensed plumber or gas fitter.
•When using ball type gas shut off valves, they shall be
•A flexible gas connector, when used, must not exceed 3 feet.
CAUTION:
THESE COOKTOPS SHOULD BE INSTALLED IN CONJUNCTION WITH A SUITABLE OVERHEAD VENT HOOD. Due to the high heat capacity of this unit, particu- lar attention should be paid to the hood and duct work installation to assure it meets local building codes.
Standard countertop and island installations:
A 1200 CFM Hood is recommended for 48" cooktops.
A 600 CFM hood is recommended for 36" cooktops.
Hoods should be 24" min. deep and the same width as the cooktop.
Island installations:
Check local building codes for the proper method of cooktop installation. Local codes vary. Installation, electrical connections and grounding must comply with applicable codes. In the absence of local codes, the cooktop should be installed in accordance with the National Fuel Gas Code ANSI
CAUTION:
These cooktops are extremely heavy. Due to the weight and size of the cooktop and to reduce the risk of personal injury or damage to the product, TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION.
Contents
Design Information |
| Installation |
|
Models Available | 3 | Step 1: Remove Packaging | 7 |
Accessory Requirements | 3 | Step 2: Cut the Countertop Opening | 7 |
Product Dimensions and Clearances | 4 | Step 3: Install the Cooktop | 8 |
Installation Options | 5 | Step 4: Conect Cooktop to Gas | 8 |
Advance Planning | 5 | Step 5: Install the Cooktop Backguard | 8 |
|
| Step 6: Connect Electrical | 9 |
Installation Preparation |
| Step 7: Assemble Burners, Check Ignition | 9 |
Tools & Materials Required | 6 | Adjustable Low Burner Settings | 10 |
Power Supply Locations | 6 | Finalize Installation | 10 |
2
