Installation
Professional Gas Cooktops
Step3
Install the Cooktop
•Lower the cooktop into the opening. Make sure the cooktop is evenly seated and sup- ported. A side frame gasket will seal the cooktop to the countertop.
•“L” brackets with screws are provided to secure the cooktop to the countertop or to adjacent cabinetry.
– Alternate screw hole locations on the sides of the cooktop allow for varying thicknesses of countertops or side cleats.
•Select the bracket location, secure the bracket to the cooktop with 2 screws.
•Drive one screw through the bottom of the “L” bracket and into countertop or side cleats.
Alternate Bracket
Screw Holes
“L” Bracket
Step4
Connect Cooktop to Gas
Amanual
Assure that gas is turned off at the shut-off valve.
•Lift and remove all open top burners to reveal the gas inlet location at the left rear corner.
•Pull the flexible metal gas line through the back or bottom of the cooktop until it meets the regular.
•Connect flexible metal connector to incoming gas line pipe stub.
•Turn on gas and check for leaks:
Flex or Rigid Gas
Line To Regulator
Regulator
Step5
Install the
Cooktop
Backguard
A backguard is required for all installations. | 2 Screws | |
• Remove the top cap of the backguard by | Top Cap | |
backing out 2 counter sunk screws. Lift off | ||
| ||
the top cap and set aside. Retain screws. |
| |
• Insert the backguard into the channel on the | 3 Screws | |
back of the cooktop. | ||
• Fasten with screws at the bottom, through |
| |
the cooktop and into the backguard. |
| |
(If a griddle is present, secure with 2 screws |
| |
on the left and center of the cooktop.) |
| |
• Secure the backguard to the wall with 3 | 3 Screws | |
screws at the top of the backguard. | ||
|
•Place the top cap in position and
8
