Care and Cleaning
Type 2 bulb replacement
NOTE: Before replacing the bulbs, review the light bulb information and WARNING on page 20.
Replacing Type 2 bulbs in lamps located inside the light shield at the top of the fresh food compartment:
1.Set the Master Light switch to the OFF position (see Using the Master Light switch) and allow the lamps to cool.
2.If the Water Filter Cartridge is installed, remove it and replace with the filter bypass plug.
3.Holding the light shield with one hand, rotate the support tabs until they clear the front of the light shield. Then push back on the light shield, lower the shield at the front and take out.
4.Remove the 4 screws securing the light housing to the ceiling. There are two screws at the front and two at the back.
Support tabs | Upper light |
| shield |
Screws
Screws
5.Lower the light housing at the front, then pull it toward you so the tabs at the back of the light housing come out of the slots on the back wall. The lamp assemblies will release from the holders.
6.Turn the lamp
protector to access the bulb.
NOTE: Always follow bulb manufacturer’s directions for handling and replacing bulbs.
7.Remove the bulb by holding the base and pulling straight out. Replace with a new bulb and replace the lamp protector.
WARNING – Lamp protectors must be replaced or the heat from the bulb could damage the refrigerator.
AVERTISSEMENT :
Vous devez remettre en place les écrans protecteurs des ampoules pour ne pas endommager votre réfrigérateur avec la chaleur produite par les ampoules.
Slots
Light housing
8.Holding up the light housing, place each lamp assembly in its holder. Feed the attached wires through the slots and tuck the wires outside the side of the light housing.
9.Insert the tabs on the back of the light housing in the slots on the back wall. Raise the light housing into position and secure with the four screws.
10.Replace the light shield and rotate the support tabs back out so they support the front of the shield.
11.Remove the filter bypass plug and replace with the Water Filter Cartridge. Reset the Master Light switch to the ON position.
22
