Using
the Master Light switch
This feature turns off the lights in the fresh food and freezer compartments.
The switch is located behind the grille panel at the top of the refrigerator. Lift up the panel to access the switch.
The switch is located behind the grille panel.
Type 1 bulb replacement
NOTE: Before replacing the bulbs, review the light bulb information and WARNING on page 20.
Replacing Type 1 bulbs located in lamps behind the top pan in the fresh food compartment and the bottom freezer basket in the freezer compartment:
1.Set the Master Light switch to the OFF position (see Using the Master Light switch) and allow the lamps to cool.
2.To access the lamps in the fresh food compartment, remove the top pan. See Drawer and Pan Removal section.
2.To access the lamps in the freezer compartment, remove the bottom freezer basket. See Freezer Baskets section.
3.On the back wall there is a curved light shield. Grasp each end of the light shield. Pull the shield toward you and the tabs on the shield will release from the slots in the housing.
4.Remove the glass above the bulbs by pulling it straight out.
NOTE: Always follow bulb manufacturer’s directions for handling and replacing bulbs.
5.Remove the bulb by holding the base and pulling straight up. Replace with a new bulb.
6.Replace the glass by sliding it into place. Then replace the light shield by resting the top lip of the shield on top of the light housing. Then press the sides until the tabs pop into the slots in the housing.
Light Shield
WARNING – The light shield must be replaced or the heat from the bulb could damage the refrigerator.
AVERTISSEMENT :
Vous devez remettre en place l’écran à lumière pour ne pas endommager votre réfrigérateur avec la chaleur produite par l’ampoule.
7.Reset the Master Light switch to the ON position.
21