Design Information
PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model.
1” |
|
13” |
19”
TOOLS AND PARTS REQUIRED (NOT SUPPLIED)
#2 Phillips screwdriver
Hand held drill
High speed drill bit, 3/32" diameter
3/8" slot head screwdriver
Level
Saw
2x4 or 2x2 lumber for installing runners or 3/8" plywood for floor (if required)
Wood screws or other hardware for installing runner or shelf to support oven (if required)
Safety glasses or goggles
PARTS SUPPLIED
6 brass screws (3 required, 3 extra)
5 color matched screws (4 required, 1 extra)
Bottom trim
ELECTRICAL TOOLS AND PARTS
REQUIRED (NOT SUPPLIED)
Junction box
Electrical cable
Wire cutters and wire strippers
4
ADVANCE PLANNING
These ovens may be installed directly into a 30” wide oven cabinet.
Cutout dimensions are NOT the same for installation with or without an accessory storage drawer. Make sure to use the correct cutout when preparing the opening.
NOTE: Model ZSC2202 CANNOT be installed with an accessory storage drawer. See Installation Preparation Without an Accessory Storage Drawer for this model.
IMPORTANT³ This oven is not approved for use above another
For personal safety, this oven cannot be installed in a cabinet arrangement such as an island or peninsula.
7KHRYHQPXVWEHLQVWDOOHGDWOHDVWµDERYH the floor.
$OORZIRUFOHDUDQFHWRDGMDFHQWFRUQHUVZDOOV drawers, etc.
&DELQHWVLQVWDOOHGDGMDFHQWWRZDOORYHQV must have an adhesion spec of at least 194ºF temperature rating.
The oven must be securely installed in a cabinet that is firmly attached to the house structure. Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit, stand or hang on the oven door.
If installing the drawer accessory, the drawer must be assembled to the oven prior to installation into the cabinet. See the Accessory Storage Drawer Assembly Instructions.
