How to Remove the Cover

Loosen but do not remove four cover screws. Lift cover off the four screws and hang on two screws (2 bottom or 2 right-hand). See Figure i and ii.

This will prevent damage to the cable. The cable may also be disconnected at the controller or keypad.

NOTE: Reattach cable before installing cover.

DANGER

HAZARDOUS VOLTAGE

Will shock, burn or cause death. Do not remove cover until ALL power is disconnected.

Re-installation of cover is required after maintenance or service.

Figure i

Figure ii

GE Zenith Controls

ZTX Operation and Maintenance Manual (62R-2000)

1

Page 3
Image 3
GE Monogram Zenith Controls, ZTX manual How to Remove the Cover, Hazardous Voltage