Integra DTR-6.2 Listening to music in the remote zone, When using the ZONE 2 SPEAKERS terminals

Listening to music in the remote zone

When using the ZONE 2 SPEAKERS terminals

Connect the speaker cables from the speakres in the remote zone (Zone 2) speaker terminals on the DTR-6.2.

With this connection, select “Activated” for the Preference → Powered Zone 2 Setup setting in the Setup menu.

Remote Zone (Zone 2)
Zone 2	Zone		2
Right		Left
speaker	speaker

ZONE 2

SPEAKERS

RL

CAUTION:

SEE INSTRUCTION MANUAL

FOR CORRECT SETTING.

DTR-6.2

Main room

Note:

•It is important to be aware of the speakerimpedance (see previous page).

•When set to “Activated,” the following limitations will be applied, so whenever you are not using the remote zone (Zone 2), be sure to return the setting to “Not Activated.”

-You can only use the Stereo and Direct listening modes in the main room.

-When listening to a multi-channel input source, no sound is output from the left and right surround speakers.

-You cannot use the Rec Out function.

When using the ZONE 2 OUT terminals

The ZONE 2 OUT terminal is a constant output. Connect to the LINE input of the amplifier (CD, tape, etc.). Adjust the volume with the amplifier connected to the ZONE 2 OUT terminal.

1.Connect the DTR-6.2 to the amplifier for the remote zone.

2.Connect the remote zone speaker cables to the speaker terminals on the amplifier.

Adjust the volume level at the amplifier.

Remote Zone (Zone 2)
Zone 2 Left	Zone 2 Right
speaker	speaker

Zone 2 amplifier

L (White)	ZONE 2
	PRE OUT
	L
	R
R (Red)
	DTR-6.2

Main room

19