Integra DTR-6.2 instruction manual Using a Macro function, Programming the Direct Macro function

Using a Macro function

ON

DIRECT MACRO

RCVR MODE

CD MODE

MODE buttons

(CD playback)

CD (INPUT SELECTOR)

Programming the Direct Macro function

With the direct macro function, you can program a series of button operations as a macro into the DIRECT MACRO button so the macro can be executed with just one touch. Note that for the direct macro function, only one macro can be programmed. For example, to program the macro described on the previous page for the DIRECT MACRO button, perform the steps given below.

1. Press and hold down any one of the eight MODE

buttons, press the DIRECT MACRO button, and then

release both buttons.

When you press the MODE button, it lights green and the

SEND/LEARN indicator lights. When you press the DIRECT

MACRO button, the indicator turns off. When you release the

buttons, the indicator flashes briefly and then lights again.

2. Press the operation buttons you wish to program in

order (in this case, press RCVR MODE → ON → CD

(INPUT SELECTOR) → CD MODE → playback ( )

button).

When you press each button, the SEND/LEARN indicator turns

off. When you release the button, the indicator lights.

3. Press the DIRECT MACRO button to complete the

procedure.

The SEND/LEARN indicator flashes twice slowly.

HOME THEATER CONTROLLER

RC-441M

Tips:

•If you erase or change the command of a button programmed in the direct macro, that operation of that button will no longer work in the macro. In this case, it will be necessary for you to reprogram the direct macro in order to avoid incorrect operation.

•The codes programmed into a direct macro will be transmitted at an interval of 0.5 seconds. However, some devices may not be able to complete one operation in 0.5 seconds and may miss the next code. In this case, after pressing one operation button, you can press the same MODE button again before pressing the next operation button to add another 0.5 seconds between the two operations.

4. Check to see if the macro has been properly

programmed.

Notes:

•You may program up to 16 button operations into the direct macro function. If you try to program a 17th operation, it will be ignored, and programming is stopped.

•If no button is pressed for more than 30 seconds during the programming, the SEND/LEARN indicator flashes three times quickly, and the remote controller exits the programming mode. Resume from Step 1.

•If you perform an invalid operation during programming, the SEND/LEARN indicator flashes three times quickly, and the remote controller exits the programming mode. Resume from Step 1.

Running a Direct Macro function

Perform the procedure below to run a direct macro function that you have programmed into the remote controller. After programming a direct macro, you should always run it at least once to make sure that it has been programmed properly.

1.Point the remote controller at the DTR-6.2 and press the DIRECT MACRO button.

It may take a while for the macro to finish transmitting, so be sure to continue pointing the remote controller at the device until the SEND/LEARN indicator turns off.

58