Integra instruction manual Enjoying music or videos with the DTR-6.2, Switching the display

Remote controller

Enjoying music or videos with the DTR-6.2

Jog dial

Display

Dimmer

CH Level

Standby/On

Rec Out

Zone 2 Zone 2 Level

CH Level

Master Volume

DSP/ Mode ADJ

Setup

Standby

Return

Power

On

Off

Push To Enter

Display

Dimmer

FM Mode

Preset Memory

Tuning

Preset

Smart Scan Navigator

Phones

Audio

Bass

Treble

Selector

DVD

Video 1

Video 2

Video 3

Video 4

Tape

FM

AM

Phono

CD

VCR 1 VCR 2

Switching the display

While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the

button on the DTR-6.2 or the DISPLAY button on the remote controller.

DTR-6.2	Remote controller
Display

When an input source other than FM or AM is selected:

Input + volume

Program format*

Input + Listening mode or Multi Ch

*If the input signal does not have a program format, then this will be skipped.

When FM or AM is selected as the input source:

FM/AM frequency +

ch

Preset no.

FM/AM +

Listening mode

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-6.2 with DIMMER button on the remote controller or Dimmer button on the DTR-6.2 front panel.

DTR-6.2	Remote controller
Dimmer

SLEEP

CH SEL

LEVEL

DISPLAY

DIMMER

HOME THEATER CONTROLLER

RC-441M

Using the sleep time (remote controller only)

The SLEEP button enables you to set the DTR-6.2 to turn off automatically after a specified time period. If you press it once, the DTR-6.2 will turn off after 90 minutes. Each time it is pressed thereafter, the remaining time until the DTR-6.2 turns off decreases by 10 minutes. While, the sleep function is enabled, you can press the SLEEP button to see how much time is left. To cancel the sleep function, press the SLEEP button when the time displayed is less than 10 minutes.

If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with main zone turned on and then put the main zone into the standby state.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 to +12 decibels. Note that the calibration settings will return to the original settings when the DTR-6.2 is put in standby.

CH Level

1. Press the CH Level button and select the desired speaker.

DSP/Mode ADJ

2.Turn the jog dial to adjust the volume level.

Push To Enter

When using the remote controller:

1. Press the RCVR MODE button.

2. Press the CH SEL button and select the desired speaker.

3. Press the LEVEL or button to adjust the volume level.

Notes:

•You cannot select a speaker if the Speaker Config sub-menu of the Speaker Setup is set to No or None.

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

•When you press the TEST button after you set the level, the current level will be used as the value set via the test tone.

30