Integra DTR-6.2 Changing the audio mode, Enjoying the multichannel output, Using the tone control

Enjoying music or videos with the DTR-6.2

Jog dial Master Volume

Standby/On	Rec Out	Zone 2	Zone 2 Level	CH Level	Master Volume
		DSP/ Mode ADJ		Setup
Standby
				Return
Power

Push To Enter

On Off

Display Dimmer FM Mode Preset Memory Tuning Preset Smart Scan Navigator

VOL

AUDIO

Phones

Audio

Bass

Treble

Selector

DVD

Video 1

Video 2

Video 3

Video 4

Tape

FM

AM

Phono

CD

VCR 1

VCR 2

		DIRECT
Audio Selector	Bass	Treble

HOME THEATER CONTROLLER

RC-441M

Changing the audio mode

Press the Audio Selector button on the front panel (or AUDIO button on the remote controller) to change the audio mode. Each time the button is pressed, the mode changes from “AUTO” → “Multich” → “Analog” and back to “AUTO.” The “AUTO” audio mode is recommended for normal circumstances.

DTR-6.2 Remote controller

Audio

Selector

AUTO (automatic detection): With this setting, the DTR-6.2 automatically detects whether the input signal is digital or analog. When a digital signal is not input, then the analog signal is played.

Multichannel: Select this setting to play back the input from the component connected to the MULTI CHANNEL INPUT port. This setting is effective when the Multichannel setting in the Audio Setup sub-menu is set to “Yes” (see pages 26, 38).

Analog: Select this setting to play back the input from a source component connected to an analog audio input jacks. With this setting, even if a digital signal is input from the same component, only the analog signal will be output.

Enjoying the multichannel output

Before starting operations, first make sure that the multichannel connection is properly made and that the Multichannel setting of the Input Setup → Audio Setup submenu is set to “Yes.”

1.Press the input source button for the component with multichannel output connected to the MULTI CHANNEL INPUT on the rear of the DTR-6.2.

2.Select “Multich” using the Audio Selector button on the front panel (AUDIO button on the remote controller).

DTR-6.2 Remote controller

Audio

Selector

3.Turn on the connected component and start playing the desired media.

4.If necessary, adjust the output level of each speaker as desired (see page 30).

Adjust the speaker output levels so that you can hear the same sound level from each speaker at the listening position. For the front right, front left, center, surround right, and surround left speakers, the output levels can be adjusted between –12 to +12 decibels. The subwoofer can be adjusted between –30 to +12 decibels.

5.Adjust the volume with the Master Volume dial or the

VOL buttons on the remote controller.

DTR-6.2 Remote controller

Master Volume

Using the tone control:

To make the BASS and TREBLE dials work for multichannel sources, you must first set the tone control to “On.”

1.Turn the tone control on by pressing either the jog dial on the DTR-6.2 or the DIRECT button on the remote controller.

DTR-6.2	Remote controller
DSP/Mode ADJ

Push To Enter

When pressed only once, the current setting appears, so press twice to change the setting.

2. Adjust the tone using the Bass and Treble dials.

Bass Treble

Notes:

•Adjusting the volume level of each speaker for the MULTI CH INPUT source does not affect the speaker level adjusted by the listening position.

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

31