Operating components not reached by the remote controller signals (IR IN/OUT)
The following equipment (sold separately) is essential for operation:
•Onkyo’s
•Multiroom A/V distribution and control systems from Niles® and Xantech® to name a few
Make connection as shown below. Do not plug the equipment into the power source until the connection is complete.
from connecting block
Mini plug cable 
If the remote controller signal does not reach the
If the
With this connection, select “Main” for the Preference → IR IN Setup → Position setting in the Setup menu (see page 42).
IR
IN
OUT
If the remote controller signal does not reach other components
IR IN
Connecting | IR Receiver |
block |
|
In this situation, you will need to use a commercially available IR emitter. Connect the mini plug of the IR emitter to the IR OUT terminal on the
In the cobinet
Remote Controller
Connecting block
IR IN
IR Receiver
: Signal flow
The IR IN input allows you to control the
With this connection, select “Zone 2” for the Preference → IR IN Setup → Position setting in the Setup menu (see page 42).
To IR IN
IR Receiver
Connecting block
Remote controller
Main room | Remote room |
: Signal flow
IR OUT
IR Emitter
Remote Controller
other component
: Signal flow
other component
: Signal flow
Remote control sensor
IR |
| Emitter |
IN |
| |
OUT | Mini plug | Mini plug cable |
| ||
IR Emitter |
|
20
