Integra DTR-6.2 instruction manual Connections, Connecting your audio components

Connections

: Signal flow

Analog audio output

L (White)

R (Red)

2. CD player (CD)

Audio connection cable

L(White)L

R(Red)R

ANTENNA	12 V
	TRIGGER	Y

PB

COMPONE

PR Y

1.Turntable (PHONO)

Digital audio output (optical)

Analog audio output

L(White)

R (Red)

AM	A
	B
FM		MONITOR
75	REMOTE	OUT
	CONTROL
PHONO CD	OUT	TAPE	IN

L

R

OUTPUT

IN

DVD

INP

OUT IN O

VIDEO 1

3.Tape deck, MD recorder, DAT deck, CD recorder, (TAPE)

Ground wire (earth)

Analog audio input

L (White)

R(Red)

L (White)

R(Red) Analog audio output

	FRONT SURR	CENTER	OPTICAL	COAXIAL
	L	1		2
GND					1
					2
	R	SUB
SUBWOOFER
	MULTI	WOOFER
PRE OUT CHANNEL INPUT			DIGITAL INPUT

Connecting your audio components

Below is an example of how you can connect your audio components to the DTR-6.2. Refer to the diagram above for the following connection examples.

1. Connecting a turntable (PHONO)

Using an RCA-type audio connection cable, connect the output terminal on the turntable to the PHONO input jacks on the DTR-6.2. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

Note:

The DTR-6.2 is designed for use with moving magnet cartridges. For proper operation, connect a ground (or earth) wire to the GND terminal. For some turntables, however, connecting the ground wire may cause increased noise, and in such a case, a ground wire is not necessary and should not be connected.

2. Connecting a compact disc player (CD)

Using an RCA-type audio connection cable, connect the output terminal on the compact disc player to the CD input jacks on the DTR-6.2. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the compact disc player has a digital output jack as well, be sure to also connect it to either a DIGITAL INPUT (COAXIAL) or DIGITAL INPUT (OPTICAL) jack on the DTR-6.2 depending on the type of connector on the compact disc player.

With the initial settings of the DTR-6.2, the CD input source is set for digital input at the OPTICAL 1 jack.

If the digital connection is made at a different jack, this must be changed at the Setup menu: Input Setup → Audio Setup → Digital Input (see pages 26, 38).

3.Connecting a cassette tape deck, MD recorder, DAT deck, or CD recorder (TAPE)

Using an RCA-type audio connection cable, connect the output terminals (PLAY) of the device to the TAPE IN jacks on the DTR-

6.2and the input terminals (REC) to the TAPE OUT jacks. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a digital output jack as well, be sure to also connect it to either a DIGITAL INPUT (COAXIAL) or DIGITAL INPUT (OPTICAL) jack on the DTR-6.2 depending on the type of connector on the device.

With the initial settings of the DTR-6.2, the TAPE input source is set for no digital input.

If you connect the device to the DIGITAL INPUT terminal, then this input source must be set for digital input at the Setup menu: Input Setup → Audio Setup → Digital Input(see pages 26, 38).

13