Integra DTR-6.2 IntelliVolume sub-menu, 2-5.12V trigger sub-menu, Setup menus, a. IntelliVolume

Setup menus

2-4. IntelliVolume sub-menu

Menu

1.Speaker Setup 2.Input Setup 2.Input Setup

Input:DVD 3.Listening Mode Setup

4.Preference 2a-.4Audio.IntelliVolumeSetup

5.OSD Setup b.VideoInput:DVDSetup

c.Listening Mode Preset da..ToIntelliVolumeControl e.IntelliVolume : 0dB

f.12V Trigger ENTER Quit:OSD

ENTER Quit:OSD

Quit:SETUP

2-5. 12V trigger sub-menu

Menu

1.Speaker Setup 2.Input Setup 2.Input Setup

Input:DVD 3.Listening Mode Setup

4.Preference 2a-.5Audio.12V TriggerSetup

5.OSD Setup b.VideoInput:DVDSetup

c.Listening Mode Preset da..Tone12V TriggerControl A :On e.IntelliVolume

fb..12VTriggger B :Off ENTER Quit:OSD

ENTER QuSD

Quit:SETUP

a. IntelliVolume

When switching input sources, you may find that the output level for different components or input sources connected to the DTR-6.2 is different even though the main volume setting is the same. Under normal circumstances, you would then have to change the volume setting each time you change the input source. This IntelliVolume sub-menu allows you to preset a volume level for each input source separately so that when you do switch from one input source to another, the DTR-6.2 adjusts the volume accordingly so that the resulting volume stays the same. To set the IntelliVolume, simply select an input source at the front panel, and if that source is quieter than other sources, increase its decibel level with the cursor button, or if it is louder than other sources, decrease its decibel level with the cursor button.

The IntelliVolume can be adjusted between –12 and +12 decibels.

This sub-menu allows you to make the required settings to turn on the output from the 12V TRIGGER terminal to control another component or device with the DTR-6.2 for each input source.

a. 12V Trigger A

On: Select to activate the device connected to the 12V TRIGGER A terminal when the input source is selected.

Off: Select when no device is connected to the 12V TRIGGER A terminal or you do not want the connected device to activate.

b. 12V Trigger B

On: Select to activate the device connected to the 12V TRIGGER B terminal when the input source is selected.

Off: Select when no device is connected to the 12V TRIGGER B terminal or you do not want the connected device to activate.

Relationship between input source and listening mode

Input source signal (display)		Analog/PCM Source	Digital Format
	Type of media	Tape, CD,	DVD,
		Record, Tuner	Digital satellite broadcast,
		DVD Video (PCM), LD (PCM)	DTS-CD
		Digital satellite broadcast	Dolby Digital 2ch Source	DTS,
				All excluding
Listening Mode				Dolby Digital 2ch
Direct		●
Stereo		●	●	●
Surround	Pro Logic II (Movie)	●	●
	Pro Logic II (Music)	●	●
	Dolby Digital			●
	DTS			●
Orchestra		●
Unplugged		●
Studio-Mix		●
TV Logic		●
All Ch Stereo		●

Notes:

•The listening modes that can be set are different for each input source format.

•You may not be able to select all the listening modes shown here depending on your speaker configuration or the selected input source.

40