Gefen EXT-HDMI1.3-244 user manual Panel Descriptions, Power LED Indicator

PANEL DESCRIPTIONS

1Power LED Indicator

This LED will become active once the included 5V DC power supply is properly connected between the unit and a open wall power receptacle.

2IR (Infrared) Receiver

This receiver will accept command for switching between input HDMI devices using the included RMT-2IR remote control.

3Internal EDID Mode LED Indicator

This LED will become active when the unit is using the pre-loaded EDID.

4External EDID Mode LED Indicator

This LED will become active when the unit is using the EDID from the HDMI deice connected to HDMI output port 1.

5Link LED Indicator

This LED will become active when the unit is properly connected to an HDMI capable device on either of the HDMI output ports.

6Currently Selected Input LED Indicator

There is one LED for each of the four input ports. The LED for the currently selected HDMI input will be active.

7EDID Button

This button will toggle between the internal external EDID modes. To determine which mode is currently being used, please note which EDID mode LED is active on the front panel of the unit.

8Reset Button

This button will reset the unit and force all devices in the chain to re-transmit/ re-read EDID. It is essential that the unit be reset after the EDID mode has been changed.

9HDMI Input Ports 1-2

Connect up to 2 HDMI source devices to these HDMI input ports. Selection between these inputs are made using the included RMT-2IR remote control.

10HDMI Output Ports 1-4

Connect up to 4 HDMI capable devices to these HDMI output ports. The currently selected HDMI input source device will be output through all of these HDMI output ports.

115V DC Power Input Port

Connect the included 5V DC power supply between this port and an open wall power receptacle.

5