CHANGING THE IR CHANNEL

Changing the IR channel

Use the following procedure to set the proper IR channel on the GefenToolBox 4x1 Switcher for HDMI.

1Press and hold the Input Select button for 5 seconds to enter IR channel selection mode. The bank of blue LED indicators will now display the currently selected IR channel.

2Press the Input Select button to cycle through each IR channel. The currently selected IR channel will by indicated by a flashing blue LED. IMPORTANT: The selected IR channel must be the same as the IR channel set on the IR Remote Control Unit (page 10). Refer to the table below for setting the IR channel.

3Once the proper IR channel has been selected, press and hold the Input Select button to confirm and exit IR channel selection mode. The currently selected input source will now be indicated.

IR Channel Table

Input LED

IR Channel

1

0

2

1

3

2

4

3

16

Page 19
Image 19
Gefen GTB-MHDMI1.3-441 user manual Changing the IR Channel, Changing the IR channel