RECEIVER PANEL DESCRIPTIONS
1.Standby Button
Pressing this will put the receiving unit in standby mode. The unit will not transfer any information to the sending unit in this mode. To release standby mode, simply press the button again.
2.Ethernet Input Port ( 1 through 4)
Connects to an Ethernet device (i.e a computer or gaming system) via a standard network cable. 4 ports are available for 4 separate devices.
3.Security/Reset Button
Pressing this button for 2 seconds will activate the Automatic Security Configuration (please see page 17). Pressing this button for more than 10 seconds will perform a factory reset.
4.AC Power Cable Input
Input for the supplied AC power cable.
5.Coaxial Output
Coaxial output to link the sending and receiving units together. This connector will support
6.LAN 1 LED
This LED will activate when a connection from a valid Ethernet device to Ethernet port 1 is established. It will blink when activity is detected to signify that data is actively being trafficked to and from this port.
7.LAN 2 LED
This LED will activate when a connection from a valid Ethernet device to Ethernet port 2 is established. It will blink when activity is detected to signify that data is actively being trafficked to and from this port.
8.LAN 3 LED
This LED will activate when a connection from a valid Ethernet device to Ethernet port 3 is established. It will blink when activity is detected to signify that data is actively being trafficked to and from this port.
9.LAN 4 LED
This LED will activate when a connection from a valid Ethernet device to Ethernet port 4 is established. It will blink when activity is detected to signify that data is actively being trafficked to and from this port.
10.Link LED
This LED will activate once a link has been established between the sending and receiving units. It will blink when activity is detected to signify that data is actively being trafficked to and from the sender.
11.Power LED
This LED will activate once the included power supply is properly connected.
7
