from end to end can be purchased from your local GEM- INI dealer.
NOTE: WHEN USING THE CROSS FADER LIGHTLY GLIDE THE FADER BACK AND FORTH. PRESSING DOWN ON THE CONTROLS CAN BEND CONTACTS AND CAUSE A LOSS OF SOUND.
FADER REPLACEMENT:
1.UNSCREW THE FADER SCREWS. DO NOT TOUCH IN- SIDE SCREWS CAREFULLY REMOVE OLD CROSS FAD- ER AND UNPLUG CABLE.
2.PLUG IN THE NEW CROSS FADER INTO CABLE AND PLACE BACK INTO MIXER.
3.SCREW THE CROSS FADER TO MIXER WITH THE FADER PLATE SCREWS
4.REPLACE THE FACE OF THE MIXER AND SCREW THE FOUR SCREWS BACK IN AND REPLACE THE FADER KNOBS.
TROUBLESHOOTING:
-If a disc will not play, check to see if the disc was loaded correctly (label side up). Also check the disc for exces- sive dirt, scratches, etc.
-If the disc turns but there is no sound, check the cable connections, if they are ok, check your amplifier or re- ceiver.
-If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CD’s are recorded out of spec and will skip on most or all CD players. Before sending the unit for repair, try playing a CD that you are sure plays properly.
SPECIFICATIONS:
GENERAL:
Type | Compact Disc Player |
Disc Type | Standard Compact discs (12 cm & 8 cm) |
Time Display | Track Elapsed, Track Remain, or Total remain |
Variable Pitch | ± 16% Slider with Resume Switch |
Pitch Bend | ± 16% Maximum |
Instant Start | Within 0.03 seconds |
Installation | 19” each |
Dimensions | 19” x 4.3” x 10.2” (482 x 110 x 260 mm) |
Weight | Main unit: 12.13 lbs. (5.5 kg) |
AUDIO SECTION:
Quantization | 1 Bit Linear/Channel, 3 Beam Laser |
Oversampling Rate | 8 Times |
Sampling Frequency | 44.1 kHz |
Frequency Response | 20 Hz to 20 kHz |
Total Harmonic Distortion | Less Than 0.05% |
Signal to Noise Ratio | 85 dB |
Dynamic Range | 85 dB |
Channel Separation | 85 dB (1 KHz) |
CDM-3610
Output Level | 2.0 +/- 0.2V R.M.S. |
Power Supply | AC 115/230V, 60/50 Hz |
INPUTS:
Phono | ............................................................................3mV,47 KOhm |
Line | 150 mV, 27 KOhm |
MIC | 1.5 mV, 1 KO balanced |
OUTPUTS:
Max | 20V |
Rec | 225 mV, 5 KOh |
S P E C I F I C AT I O N S A N D D E S I G N A R E S U B J E C T T O C H A N G E W I T H O U T N O T I C E F O R P U R P O S E O F I M P R O V E M E N T.
7
