15.STOP: The STOP (16) button ends CD play.
16.SINGLE: Pressing the SINGLE (15) activates the AUTO CUE func- tion. You will notice the AUTO CUE blinking in the LCD (20) when this mode is engaged. The AUTO CUE function causes the unit to pause at the beginning of music of the following track & allows you to start play imme- diately from the start of music without any blank space (which exists at the beginning of every track). Pressing the SINGLE (15) button a second time activates the CONTINUOUS function causing the unit to play continuous- ly (after the last track, the unit will return to the first track of the disc & con- tinue to play). Pressing the SINGLE (15) button a third time deactivates the CONTINUOUS function.
17.TIME/OUTRO: The TIME (17) button switches the time display between the 4 available choices listed under LCD (20). This also switch- es on/off the OUTRO function, which only plays the last 30 seconds of each track.
18.PITCH: Pushing the PITCH (14) button activates the PITCH CON- TROL SLIDE (12). The pitch of the CD will change according to the posi- tion of the PITCH CONTROL SLIDE (12).
19.PITCH BEND: Pushing the PITCH BEND (13) buttons will automati- cally raise the pitch up to +16% or lower the pitch down to
20.PITCH CONTROL SLIDE: Moving the PITCH CONTROL SLIDE (12) up or down will lower or raise the pitch percentage.
OPERATIONS:
1.Press the OPEN/CLOSE (6) button, place a CD in the DISC TRAY (7) & press the OPEN/CLOSE (6) button again. The tray will close into the unit.
2.Push the TRACK SKIP (19) buttons to select the track you want to play.
3.Press the PLAY/PAUSE (9) buttons & the unit will instantly play.
CDG OPERATIONS:
1.After making the proper connections & the power for the
NOTE: You may only use CDG discs to display the lyrics on a screen. Other CD formats will not display the lyrics.
2.Turn on the monitor screen & wait until the
3.Push the TRACK SKIP (19) buttons to select the track you want to play.
4.Press the PLAY/PAUSE (10) buttons & the unit will instantly play.
CUES:
1.To program a cue point (the spot on a CD at which you want play to start) select a track & push PLAY/PAUSE (10) so the unit enters the PLAY mode. (PLAY/PAUSE LED glows green).
2.When the CD reaches the approximate musical spot you wish to make your cue, push PLAY/PAUSE (10) so the unit enters the PAUSE mode (PLAY/PAUSE LED blinks & the unit will enter stutter mode). Move the SEARCH DIAL (9) forward or in reverse until you reach the precise frame is located, at which point you will want the CD to begin play. Push CUE (11). The cue point is now programmed, the blue LED will remain on. Press & hold CUE (11) to preview the cue point. Release CUE (11) to return to the cue point. Press CUE (11) to return to this
NOTE: Once you have skipped to another track, you may not go back to your programmed
cue point. You must begin your cue selection over again once you have skipped to another track. The cue will be preset to the beginning of the selected track. Press the cue button & you will begin at the beginning of your selected track. Start your Cue programming sequence over again.
3.To fine tune your
4.If, however, the selected spot is not exactly where you want it, push the CUE (8) button while the CD is playing & the disc will return to the pre- programmed cue point. Repeat step #1 - #3.
NOTE: During fine tuning there will be a stutter effect (to help you find the beat). The stut- tering effect will end when you press the PLAY/PAUSE (9) to save the cue point.
TROUBLESHOOTING:
·If the disk will not play, check to see if the disc was loaded correctly (label side up). Also check the disc for excessive dirt, scratches, etc.
·If the disc turns but there is no sound, check the cable connections. If they are okay, check your amplifier or receiver.
·If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CDs are recorded out of spec & will skip on most or all CD players. Before sending the unit in for repair, try playing a CD that you are sure plays properly.
·If the CDG does not display the song title & lyrics, please check & make sure that the CDG is not an audio CD or
SPECIFICATIONS:
GENERAL:
Type | Compact Disc Player |
Disc Type | Standard Compact discs (12 cm & 8 cm) |
Time Display | Track Elapsed, Track Remain, or Total remain |
Variable Pitch | ± 16% Slider with Resume Switch |
Pitch Bend | ± 16% Maximum |
Instant Start | Within 0.03 seconds |
Track Selection | 1 to 99 Tracks |
Installation | 19" each |
Dimensions | 19” x 3.5” x 10” |
Weight (total) | 10.21 lbs. (6.21 Kg) |
AUDIO SECTION:
Quantization | 1 Bit Linear/Channel, 3 Beam Laser |
Oversampling Rate | 8 Times |
Sampling Frequency | 44.1 kHz |
Frequency Response | 20 Hz to 20 kHz |
Digital Output | IEC958 |
Total Harmonic Distortion | Less Than 0.05% |
Signal to Noise Ratio | 85 dB |
Dynamic Range | 85 dB |
Channel Separation | 85 dB |
Output Level | 2.0 +/- 0.2 V R.M.S. |
Power Supply | AC 115/230 V, 60/50 Hz |
Specifications & design are subject to change without notice for purpose of improvement.
(5)
