Disarming Your System / Silencing an Alarm
Disarming Your System when Returning
1Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to disarm the system before your Entry Delay time expires.
2Enter your User Code and press . The red Armed light will go out, indicating that the system has been disarmed.
Note: If you make a mistake entering your code, press and
Alarm Indication
If the Red Armed light is flashing rapidly, an alarm occurred while you were away. Proceed with caution! For your own protection, leave immediately and call authorities from a neighbors phone .
Silencing an Alarm
In the event that the system goes into alarm due to a violated burglary zone, the siren and the keypad sounder will activate and the number of the zone in alarm will flash in the display. To silence the system, enter your User code followed by.
The keypad sounder and siren will silence, but the zone in alarm will continue to flash. Pressto reset this alarm memory.
Silencing a Fire Alarm
In the event that the Fire alarm activates due to an violated smoke or fire detector, the bell or siren will sound a distinct pulsating tone. FIRE on the keypad will be flashing, and the keypad sounder will emit a pulsing tone. If a Fire Alarm does occur:
1If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone.
2 If there is no evidence of a fire, enter your User Code followed by . The bell or siren will silence, and FIRE | will |
stop flashing, but will still be lit. |
|
3Determine which device went into alarm. If you are protected by smoke detectors, the light on the active detector will be lit. Once it is determined which smoke detector is in alarm, pressto reset the fire zone.
4 If the Fire zone has reset properly, FIRE should go out in approx. 30 seconds. If it does not go out, press
again in a few minutes. If it still does not go out, call for service.
8
Oi219c | Tuesday, September 16, 1997 08:24 |
page 8 |
|
