Generac Portable Products SE10000 Generator
TROUBLESHOOTING
Problem |
| Cause |
| Solution | ||
|
| |||||
Engine is running, but no AC |
| 1. Circuit breaker is open. |
| 1. | Reset circuit breaker. | |
output is available. |
| 2. Poor connection or defective cord |
| 2. | Check and repair. | |
|
|
| set. |
|
|
|
|
| 3. | Connected device is bad. |
| 3. | Connect another device that is in |
|
|
|
|
|
| good condition. |
|
| 4. | Fault in generator. |
| 4. | Contact Generac service facility. |
|
|
|
|
|
| |
Engine runs good but bogs |
| 1. Short circuit in a connected load. |
| 1. | Disconnect shorted electrical load. | |
down when loads are |
| 2. Generator is overloaded. |
| 2. | See “Don’t Overload the | |
connected. |
|
|
|
|
| Generator” on page 11. |
|
| 3. | Engine speed is too slow. |
| 3. | Contact Robin service facility. |
|
| 4. | Shorted generator circuit. |
| 4. | Contact Generac service facility. |
|
|
|
|
|
| |
Engine will not start; or starts |
| 1. Dirty air cleaner. |
| 1. | Clean or replace air cleaner. | |
and runs rough. |
| 2. Out of gasoline. |
| 2. | Fill fuel tank. | |
|
| 3. | Stale gasoline. |
| 3. | Drain gas tank and fill with fresh |
|
|
|
|
|
| fuel. |
|
| 4. | Spark plug wire not connected to |
| 4. | Connect wire to spark plug. |
|
|
| spark plug. |
|
|
|
|
| 5. | Bad spark plug. |
| 5. | Replace spark plug. |
|
| 6. | Water in gasoline. |
| 6. | Drain gas tank; fill with fresh fuel. |
|
| 7. | Overchoking. |
| 7. | Put choke lever to “no choke” |
|
|
|
|
|
| position. |
|
| 8. | Low oil level. |
| 8. | Fill crankcase to proper level. |
|
| 9. | Excessively rich fuel mixture. |
| 9. | Contact Robin service facility. |
|
| 10. Intake valve stuck open or closed. |
| 10. Contact Robin service facility. | ||
|
| 11. Engine has lost compression. |
| 11. Contact Robin service facility. | ||
|
|
|
|
|
| |
Engine shuts down during |
| 1. Out of gasoline. |
| 1. | Fill fuel tank. | |
operation. |
| 2. Low oil level. |
| 2. | Fill crankcase to proper level. | |
|
| 3. | Fault in engine. |
| 3. | Contact Robin service facility. |
|
|
|
|
|
| |
Engine lacks power. |
| 1. Load is too high. |
| 1. | See “Don’t Overload the | |
|
|
|
|
|
| Generator” on page 11. |
|
| 2. | Dirty air filter. |
| 2. | Replace air filter. |
|
| 3. | Engine needs to be serviced. |
| 3. | Contact Robin service facility. |
|
|
|
|
|
| |
Engine “hunts” or falters. |
| 1. Choke is opened too soon. |
| 1. | Move choke to halfway position till | |
|
|
|
|
|
| engine runs smoothly. |
|
| 2. | Carburetor is running too rich or |
| 2. | Contact Robin service facility. |
|
|
| too lean. |
|
|
|
14
