Generac Portable Products SE10000 Generator
WHEEL KIT INSTALLATION
You will need a 13mm metric box, open end or socket wrench to install this kit.
Install Wheel Kit as follows: (Figure 3)
1.Place the bottom of the generator cradle on a flat, even surface. It may help to raise the cradle on temporary blocks.
2.Slide axle through both axle mounting brackets on cradle frame.
3.Slide spacer over each end of axle.
4.Install the wheel. Secure wheel on axle with retaining pin and washer. Be sure to install the wheel with the raised hub inboard.
5.Install other wheel in the same manner.
6.Secure the vibration mount on the support leg with lock nut, washer, and 30mm capscrew. Fasten the support leg to the bottom of the generator cradle, using 20mm capscrews, lock washers and flat washers.
7.Position the handle below the muffler bracket on the engine side of the generator. Attach the handle with 45mm capscrews and lock nuts.
8Recheck all nuts to make sure they are tight and secure. Remove the temporary blocks.
Figure 3 — Wheel Kit
|
| Handle |
|
|
|
|
| 45mm Capscrew | |
|
| Locking Nut |
|
|
|
|
|
| Support Leg |
|
| Locking |
|
|
|
| Nut |
|
|
|
| Vibration |
| Flat Washer |
Axle | Spacer | Mount | M8 Flat | Lock Washer |
| ||||
|
| |||
|
|
| Washer |
|
|
|
| 30mm | 20mm Capscrew |
|
|
|
| |
|
|
| Capscrew |
|
|
| Washer |
|
|
| Wheel | Retaining Pin |
|
|
|
|
|
| |
|
| 5 |
|
|
