Generac Portable Products SE10000 Generator
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
IMPORTANT: Any attempt to run the engine before it has been serviced with the recommended oil will result in an engine failure.
REMOVE GENERATOR FROM CARTON
•Set the palleted carton on a rigid flat surface.
•Carefully cut bands around the shipping carton.
•Lift carton off the generator.
•Remove all packing material, carton fillers, etc.
•Remove the generator from the shipping pallet.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call the generator helpline at
•10,000 watt generator
•Generator owner’s manual
•Engine owner’s manual
•2 Bottles of SAE 30 engine oil (28 oz.)
•Oil fill spout
•125 Volt, 30 Amp plug
•125 Volt, 20 Amp plug
•120/240 Volt, 30 Amp plug
•Wheel kit
CHECK BATTERY / ATTACH NEGATIVE BATTERY WIRE
The battery on the generator is fully charged, sealed and
To install:
•Remove nut on the negative battery terminal.
•Slide the negative battery cable over the screw on the terminal (Figure 2).
Figure 2 — Negative Battery Connection
•Reattach nut and tighten.
•Ensure the connections to the battery and generator are tight and secure.
4
