1OVERVIEW OF POWERHEAD CONTROLS
This section describes the simple programming functions. Use this page to familiarize yourself with the buttons and LED indicators used to program the opener.
NOTE: These and buttons are for programming use only. Do NOT use these buttons to operate the opener.
There are three programming buttons and two lights (LEDs) on the powerhead.
Each of the buttons are used to enter and complete the setup programming. The LEDs indicate status or a function change by illuminating ON, OFF, or ON flashing in one of three different colors: BLUE, RED, or PURPLE.
Begin here ONLY AFTER completing assembly and installation of the opener. Review the Assembly & Installation Poster to ensure all steps have
Facing
Garage Door
PROGRAM
|
| Close Travel OpenTravel |
ROUND LED | PROGRAM | Button |
Indicator |
| |
|
|
LONG LED | SET |
Indicator |
|
Located on bottom of Powerhead.
been performed.
There are no assembly or installation steps included in this manual. Contact your Genie® Professional Dealer for an installation poster, if needed, or call
Enters into and selects programming menus.
SET
Both LEDs can be Red, Blue, Purple or off, depending on the programming step you are performing.
INFRARED PROTECTION FUNCTION
1.The
2.If the
3.When the garage door is closing, if
4.If the
a pdf. file.
Before you begin Programming, check to make sure there are no objects in the garage
door opening.
Programming Overview
There are four Powerhead program menus:
Remote Program (Default menu)
Limits Program
Force Program*
Speed Program**
ADJUSTMENT OF FORCE & SPEED SETTINGS IS ON PAGE 10 IN THE MAINTENANCE & TROUBLESHOOTING SECTION.
*Force settings are set at the factory and do not normally require operator programming but can require minor adjustment under certain conditions.
See Troubleshooting.
**Speed settings are set at the factory and are self- adjusting when needed. Speed Settings do not normally require manually initiated changes.
9/2011 | ©2011 The Genie Company | 4 |