Function Tests, Setup, Machines Without Stabilizers

Third Edition • Second Printing	Operator's Manual

Function Tests

1Select a test area that is firm, level and free of obstructions.

1Remove the leg retainer pin and lower the leg to the down position. Insert the pin through the leg and base.

FUNCTION TESTS

1Place a 2 inch / 5.1 cm block under one leg swivel caster.

2Loosen the arm lock knob on the opposite adjustable arm. Push down on the lock knob.

3Position the adjustable arm to the desired width.

4Tighten the arm lock knob while supporting the leg assembly.

5Repeat steps 1-4 for the other arm.

1Push down to release the stabilizer lock plates and lower the stabilizers until the casters are in full contact

with the ground. Be sure the stabilizers are locked in the down position.

2Remove the leg retainer pin

and lower the leg to the down position. Insert the pin through the leg and base.

Load Handling Attachments Standard Forks and Standard Fork Options

1Place the forks inside the carriage.

2Insert the retaining pin.

Load Platform with Standard Forks 1 Place the load platform on the standard forks. Pipe Cradle

1Attach the pipe cradles to the forks. Be sure the fasteners are tightened.

1Slide each extension tube onto the fork.

2Adjust to the desired position and insert the retaining pins.

Part No.97550

Genie Superlift Advantage