Operator's Manual | Third Edition • Third Printing | |
|
|
|
|
|
|
OPERATING INSTRUCTIONS
Battery and Charger Instructions
Observe and Obey:
Do not use an external charger or booster battery.
Charge the battery in a
Use proper AC input voltage for charging as indicated on the charger.
Use only a Genie authorized battery and charger.
To Charge Battery
1Be sure the batteries are connected before charging the batteries.
2Open the battery compartment. The compartment should remain open for the entire charging cycle.
3Remove the battery vent caps and check the battery acid level. If necessary, add only enough distilled water to cover the plates. Do not overfill prior to the charge cycle.
4Replace the battery vent caps.
5Connect the battery charger to a grounded AC circuit.
6The charger will indicate when the battery is fully charged.
7Check the battery acid level when the charging cycle is complete. Replenish with distilled water to the bottom of the fill tube. Do not overfill.
Dry Battery Filling and
Charging Instructions
1Remove the battery vent caps and permanently remove the plastic seal from the battery vent openings.
2Fill each cell with battery acid (electrolyte) until the level is sufficient to cover the plates.
Do not fill to maximum level until the battery charge cycle is complete. Overfilling can cause the battery acid to overflow during charging. Neutralize battery acid spills with baking soda and water.
3Install the battery vent caps.
4Charge the battery.
5Check the battery acid level when the charging cycle is complete. Replenish with distilled water to the bottom of the fill tube. Do not overfill.
24 | Genie | Part No. 82750 |
