Connections
Do not connect the power cord until all other connections have been made.
Connecting the satellite (front, center, surround) speakers and the subwoofer
7Assembling the front and surround speakers for
TH-P7
Front speaker | Surround | Stand (4) Base plate (4) | |
speaker |
|
| |
| (2) |
| |
•Check the model name of each speaker from the label on the rear to locate each speaker correctly.
Assembled speakers:
| or | ||
|
|
|
|
With stand: Refer to steps 1 | Without stand: Refer to steps | ||
to 3. | 2 and 3. | ||
Before assembling —
• Prepare a Phillips screwdriver (not supplied).
• Take care not to drop any component part while assembling; otherwise, it may cause damage to the floor or personal injury.
1
Speaker
Stand
Screw M5 x 40 mm
(supplied)
2When assembling a speaker without stand:
Speaker
A: Use these screws (M4 x
45 mm) when assembling the speaker with the base plate.
Base plate
Stand (or speaker directly)*
Screw M4 x 20 mm (supplied)*
*When assembling the speaker with the base plate, use the screws A.
3
Red White
Black | Black |
You can route the speaker cord by using speaker cord clamp (supplied).
Precautions for daily use
•When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury.
•When holding a speaker, always grasp the lower portion.
•Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.
•Do not reproduce sounds at so high a volume that the sound is distorted; otherwise, the speakers may be damaged by internal heat buildup.
8