MASTER STATUS LED INDICATORS - Outpu t status LED’s are provided to indicate Signal present and
Clipping. The Green LED monitors the pre Mast er Volume output signal fro m the preamp before the power amp
secti on. The Red L ED indicate s Clip/Lim it and indicate s that the maximum power threshold has been crossed and
the internal “so ft-clip” limiter is active. Driving the amp 6db b eyond this point will cause gradual clipping.
CHANN EL INSERTS / EFFECTS LOOP – The Shenandoah™ 200 is equipped with insert point s on each
channel AND on the left and ri ght main signal paths. These points are handy for inserting compressors and
dedicated digital effects processors. Signal is line level and unbalanced.
DIRECT OUTPUTS – The Shenandoah™ 200 contains the most comprehensive direct output section
sense” when connecting with other equipment. The ¼” unbalanced outputs are true professional line level (+4 dbv)
long cab le lengths (250+ feet) without problems or added noise and is compatibl e wi th all commonly encountered
mixing consoles. The XLR balanced direct outputs can be “ground lifted��� with the global ground lift switch. This
switch lifts pin 1 on all of the XLR balanced outputs to break ground a ny loops between the Shenandoah™ 200 and
a PA syst em (or recording) console Direct outputs are provided for each channel, pre eq, pre effects, post channel
volume (to take advantage of the dual summing inputs on each channel), and for left a nd ri ght mixed outputs, post
POWER AMPLIFIER
circuits that are completely protected against overloads, short circuits and thermal fa ults. Output is rated at 100 watts
a very cool feature that increases pro duct reliability 10-fold over conventional designs. An internal cooling fan is
provided for maximum heat e xhaust through the front panel vents.
TUNER OUT – This jack is provided for use with all tuners that accept a ¼” input. The signal from this ja ck is
always present and works well with all known tuners .
EFF ECTS J ACK – This jack is provided for use with the 2 b utton DSP footswitch with comes standard with the
Shenandoah™ 200. This foots witch turns both DSP A and B programs ON a nd OFF. This is a useful tool for pre-
selecting programs and then turning them on o r off when desired.
SPEAKER OUTPUT JACKS – The Shenandoah 200 provides 2 sets of parallel ¼” speaker output jacks.
Minimum total load is 4 ohms (2 x 8 ohm loudspeakers) on each output channel. The combo is equipped with a 10”
- 8 ohm loudsp eaker and compression tweeter per side and may drive an additional 8 ohm extens ion speaker
cabinet per side. We offer the Shen-200 EXT L/R spe aker enclosures that are a matched pair of Left and Right
imaged extension spea kers that offer the same complimen t of 10” woofer a nd compression tweeters like those in the
Shenandoah™ 200.
POWER INPUT – The Shenandoah™ 200 is shi pped from the factory with a st andard IEC type power i nlet
universal input (115/230 volt, 50/60 Hz) w ith a voltage selector switc h located above the in let conn ector. Be sure that
this swi tch is i n the correct position (matching yo ur local p ower system) BEFORE connecting the Shenandoah™ to
the power so urce. There is an AC mains fuse (with a spare fus e included!) located in the small sli de out tray on the
IEC power inlet connector. Always repl ace w ith the correct value fuse as indicated on the fuse chart located on the
TWEETER LEV EL CONTROL S – A Tweeter Level Control is provided on each side of the speaker enclosure
4