Mounting
Hole
Spring
Loaded Pin
Mounting
Hole
Pin
Long Bolt,
Lock Washer
and Flat
Washer
Door Stop

Assembly Instructions (cont)

6.Attach the Upper Frame Support to the front of the cart, as shown (with screw holes on top). Secure both ends in place with a Short Bolt, Lock Washer and Flat Washer.

Attach the Lower Frame Support to the cart by inserting the extension knobs into the mounting holes. Slide the Lower Frame Support down to lock it in place. Pin on Support must meet with keyhole slot in side rails.

Secure the Door Stop in place with a Long Bolt, Lock Washer and Flat Washer as shown.

Upper Frame

Support

Lower Frame Support

7. On the bottom hinge-side

of each door is a pin that extends about 1/2". The

top hinge-side contains a mounting hole. The Upper

Frame Support contains a spring-loaded pin, one at

each end of the Support. The Base Panel contains

mounting holes designed to accept the pins on the

lower end of the Doors. Attach the right door by

Inserting the hinge pin at the bottom of the Door

into the mounting hole in the Base Panel. Raise the spring-loaded pin in the

Upper Frame Support , align the mounting hole in the top of the Door and release the spring-loaded pin to secure the Door in place. Repeat this procedure with the left Door.

8.At this point, securely tighten all the hardware. The cart is now fully assem- bled and ready to accept the Lid and Grill Assembly.

12