Instructions For Cleaning

CAUTION: Grill surfaces become hot during use. Allow all parts to cool completely before handling and cleaning.

1.Turn the Burner Control Knobs to the OFF position and allow the Grill to cool before disassembling and cleaning.

2 Remove and empty the Drip Tray.

3.Wash the Cooking Grids, Heat Plates, Drip Pan and Drip Tray with warm, soapy water and, if necessary, a plastic scouring pad. Rinse and dry thoroughly. Do not use steel wool, coarse scouring pads or harsh or abrasive cleaners. If neces- sary, use a nylon bristle brush to loosen hardened food particles.

4.Wash exterior parts with a soft sponge and warm clear water. Non-abrasive cleaners may also be used. Be sure to scrub with the grain direction of the stainless steel.

5.Use a damp cloth to clean the inside of the Lid and Grill Body.

Cleaning the Side Shelf Burner Assembly

IMPORTANT: Clean the burner assembly prior to use after storing, at the beginning of the grilling season or an inactive period of one month. Spiders and insects like to build nests in burner tubes, especially during colder months. The nests can cause fires in burner tubes or under grill.

In order to clean the inside of the burner tube, the Side Shelf Burner Assembly must be removed from the Grill.

1.Make sure the gas cylinder has been turned OFF. Disconnect the gas line from the Regulator to the Burner then disconnect the Ignitor Wire from the Ignitor. DO NOT pull on the wire itself. Grasp the crimped end of the connector and gently pull straight down to disconnect.

2.Raise the Side Shelf Burner cover. Remove the cast iron cooking grate and the brass diffuser from the center of the burner. Inspect the diffuser and clean it as needed.

3.Remove the three mounting Bolts, Lock Washers and Flat Washers that secure the Side Shelf to the grill. Lift the Side Shelf up and away from the grill then set the assembly upside down on a clear, stable working surface.

4.Two small screws, lock washers and flat washers are used to secure the burner to the Side Shelf. Remove the screws and washers. Lift the burner from the Side Shelf. Inspect both ends of the burner and clean it as needed.

5.Carefully reassemble the Burner Assembly, making sure the mounting screws are tight, all parts have been properly reassembled and the Ignitor Wire has been reconnected to the Ignitor.

6.Clean the outside of the Side Shelf Burner assembly with a paper towel or damp sponge

Storing Your Propane Grill

1.Cover Grill if stored outdoors. Store Grill indoors only if the propane cylinder is turned off and disconnected, removed from Grill and stored outdoors in a well- ventilated space and out of the reach of children.

2.When removing Grill from storage, follow the Cleaning the Side Shelf Burner

Assembly instructions before starting the Grill.

Any service requiring disassembly other than the above cleaning must be performed by an authorized appliance repair technician. Do NOT ship gas cylinder if product needs service or repair.

19