Assembly Instructions (Cont.)
15.Insert the Drip Pan into the back of the Grill then insert the Drip Tray into slots beneath the Drip Pan. See view below.
16.Attach one end of the regulator gas line to the fitting that feeds the Side Shelf Burner, see Detail A. Attach the other line to the fitting that feeds the four burners in the Grill, see Detail B. Make sure the fittings are tight. Refer to the Leak Test section in this manual and be sure to follow all the steps. Connect the Ignitor wire to the Ignitor beneath the burner, as shown in Detail C,. by simply pushing it on to the crimped end of the Ignitor.
Detail A | Detail C |
| |
| Drip Pan |
Regulator | Shelf |
Detail B
17.Install the AA Battery into the Ignitor. Unthread the Ignitor Button Assembly on the front of the Control Panel, drop in the battery, negative end down, then screw on the Ignitor Button Assembly
18.Fasten the Tank Clamp Bracket (short) to the upper position and the Tank Support Bracket to the lower position by inserting the top end of each Bracket into the access slots in the right Side Panel and securing them in place with Short Bolts, Lock Washers and Flat Washers.
19.Hang the 20 pound LP cylin- der on the Brackets and connect the regulator to the tank. Tighten securely by hand.
Tank Clamp
Bracket
Tank Clamp
Support
16