8)F_PANEL (2x10 pins connector)
| MSG+ | MSG- | PW+ PW- |
| SPK- | |
2 | 1 |
|
| 1 | 1 | 20 |
|
|
| 1 |
| ||
1 1 |
|
|
| 19 | ||
|
|
| N C | |||
| HD+ HD- | RES- | RES+ |
|
HD (IDE Hard Disk Active LED) | Pin 1: LED anode(+) |
(Blue) | Pin 2: LED |
|
|
SPK (Speaker Connector) | Pin 1: VCC(+) |
(Amber) | Pin 2- Pin 3: NC |
| Pin 4: |
|
|
RES (Reset Switch) | Open: Normal Operation |
(Green) | Close: Reset Hardware System |
|
|
PW (Soft Power Connector) | Open: Normal Operation |
(Red) | Close: Power On/Off |
|
|
MSG(Message LED/Power/ | Pin 1: LED anode(+) |
Sleep LED)(Yellow) | Pin 2: LED |
|
|
NC( Purple) | N C |
|
|
ØPlease connect the power LED, PC speaker, reset switch and power switch etc ofyour chassis front panel to the F_PANELconnector according to the pin assignmentabove.
9)BATTERY(Battery) | CAUTION |
| v Danger of explosion ifbattery is incorrectly |
| replaced. |
| v Replace only with the same or equivalent |
+ | type recommendedbythe manufacturer. |
| v Dispose of usedbatteries according to the |
| manufacturer’sinstructions. |
If you want to erase CMOS...
1.Turn OFF the computer and unplug the power cord. 2.Remove the battery, wait for 30 second.
4.Plug the power cord and turn ON the computer.
English
- 19 - | Hardware Installation Process |