JVC HM-DH5U manual DBS Receiver Control Setting, Connect DBS receiver to VCR

EN 25

DBS Receiver Control Setting

Suggested location

Place the DBS (Direct Broadcast Satellite) receiver on top of the VCR. Attach the VCR’s Controller to the top of the VCR with the Controller’s transmitter pointed towards the DBS receiver’s remote sensor.

ATTENTION:

The Controller can also control a cable box. If both a DBS receiver and a cable box are used, position the Controller so its signal reaches the remote sensors on both the DBS receiver and cable box.

DBS receiver

		Controller
		(suggested
Your VCR		locations)
	DBS receiver
Controller
(supplied)	To RF	To Audio/
	output	video output
	Transmitter
		or
	To [ANTENNA	To [AUDIO/
	IN]	VIDEO INPUT]

Your VCR

CABLE

BOX

The following procedure is required if you receive satellite channels through a DBS (Direct Broadcast Satellite) receiver. The Controller allows the VCR to automatically switch the DBS receiver’s channels during timer recording.

NOTES:

•The VCR can automatically change the DBS receiver channels

using the Controller when the VCR has been programmed using Express timer programming (A page 44).

Because satellite programming does not use PlusCode, the Controller cannot change the DBS receiver channels during

VCR Plus+ timer recording. (You can also use ‘Satellite Auto Recording’ (A page 47) if your DBS receiver is equipped with a timer.)

•If a cable box is also used, it is recommended that you connect the DBS receiver to your VCR’s [AUDIO/VIDEO INPUT] connectors and the cable box to your VCR’s [ANTENNA IN] terminal.

Installing Controller

ASituate Controller

Place the Controller so that its transmitter is facing the DBS receiver’s remote sensor.

•Make sure the path between the Controller and the DBS receiver’s remote sensor is not blocked.

BAttach Controller

Fix securely using the adhesive strip attached on the back of the Controller.

CConnect DBS receiver to VCR

•If your DBS receiver does not have audio/video output connectors

Connect the RF output terminal on the DBS receiver to the [ANTENNA IN] terminal on the rear of your VCR.

•If your DBS receiver has audio/video output connectors

Connect an audio/video cable between the [AUDIO/VIDEO INPUT] connectors on the rear of the VCR and the audio/video output connectors on the DBS receiver.

NOTE:

When connecting your DBS receiver, refer to its instruction manual.

D Connect Controller to VCR

Connect the Controller to the CABLE BOX

Controller connector on the rear panel.

How to control the DBS receiver

This VCR has two separate methods to control your DBS receiver.

•The VCR’s wireless Remote can control your DBS receiver. This eliminates the need for a separate DBS receiver’s Remote.

•The VCR’s Controller can also control your DBS receiver. This allows the VCR to change your DBS receiver’s

channel number during timer-recording.

Each method must be set up separately. To set up the VCR’s Remote, refer to page 77. To set up the Controller, go to page 26.