JVC HM-DH5U Blinks on the front display, There are no programs in memory, Again, Correct number a

			EN 81
TIMER RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
4.	[j] blinks on the front display	• The timer is engaged but there is no	Load a cassette with the record safety
	panel.	cassette loaded.	tab intact, or with the hole covered
			with adhesive tape.
		• [TIMER (j)] has been pressed when	Check the programmed data and set
		there are no programs in memory,	again if necessary, then press [TIMER
		or the timer recording program has	(j)] again.
		not been set correctly.
5.	[j], [X] and [E] on the front dis-	• The loaded cassette has had its	Remove the cassette and cover its
	play panel will not stop blinking	record safety tab removed.	hole with adhesive tape, or replace it
	when the timer is engaged.		with a cassette on which the safety
			tab is intact.
6.	The cassette stops automatically,	• The tape reaches its end during	The program may not have been
	and [j], [X] and [E] on the front	timer recording.	recorded in its entirety. Next time be
	display panel will not stop blink-		sure you have enough time on the
	ing.		tape to record the entire broadcast.
7.	Cable channels are not automati-	• The Controller is not properly	Connect the Controller correctly
	cally switched during timer	connected to the VCR.	(A page 22).
	recording.	• The input channel selected on the	After confirming your cable box’s
		Cable Set Up screen is incorrect.	input channel number, re-access the
			Cable Set Up screen and select the
			correct number (A page 23).
		• The cable box is turned off.	Make sure the power is on before
			timer recording starts.
8.	Satellite channels are not auto-	• The Controller is not properly	Connect the Controller correctly
	matically switched during timer	connected to the VCR.	(A page 25).
	recording.	• The input channel selected on the	After confirming your DBS receiver’s
		DBS Receiver Set screen is	input channel number, re-access the
		incorrect.	DBS Receiver Set screen and select
			the correct number (A page 26).
		• The VCR is not set correctly to	Set the correct DBS receiver brand
		control the DBS receiver.	code (A page 27).
		• The DBS receiver is turned off.	Make sure the power is on before
			timer recording starts.
9.	Timer recording begins as sched-	• Even though you do not use an	Set “INPUT CH” to “OFF”
	uled, but the channel is always	external cable box or DBS receiver,	(A pages 23, 26).
	incorrect.	on the Cable Set Up screen or DBS
		Receiver Set screen, “INPUT CH” is
		set to “ON”.
10. You moved, and now VCR Plus+		• The receivable stations in the new	Re-perform the Changing VCR Plus+
	system does not work properly.	area are received on different	Setting procedure (A page 42).
		channels than those in the previous
		area.
11.	“PROGRAM FULL” is displayed	• All 24 programs of the VCR’s timer	Wait until a space in memory clears,
	on the screen.	memory are used.	or cancel unnecessary program
			information (A page 46).
VIDEO NAVIGATION
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Tape information screen does not	• The current tape inserted has not	Tape information cannot be shown if
	appear for the currently inserted tape.	been recorded on this VCR.	it has not been recorded on this VCR.