JVC HM-DH5U manual Connections, 12 EN

Antenna or Cable for digital broadcast

12 EN INSTALLING YOUR NEW VCR

Connections

To [i.LINK IN/OUT]

Back of VCR

i.LINK Cable (not supplied)		To i.LINK Input/Output Connector
	Flat Feeder
		Antenna or Cable
Matching Transformer	Coaxial Cable
(not supplied)	To [ANTENNA IN]	Integrated HDTV
	(Antenna or cable
	input)

i.LINK IN/OUT	HDMI OUT OPTICAL
DV IN
S400
D-THEATER	PCM/STREAM
REGION 1
	DIGITAL AUDIO OUT

AC Outlet

	S-VIDEO	S-VIDEO		To [ANTENNA
	VIDEO	VIDEO	ANTENNA
			VHF/UHF	OUT]
Y			IN		RF Cable (supplied)
PB/CB	L	L
	AUDIO	AUDIO	CABLE BOX
PR/CR	R	R	OUT
COMPONENT		L-1 L-2	ANTENNA
VIDEO OUT	OUTPUT	INPUT	REMOTE PAUSE/			To 75K terminal
			AV COMPULINK
		To [S-VIDEO OUTPUT]			S-Video Cable	To S-Video Input
					(supplied)	Connector	To HDMI
	S-VIDEO
					Video Cable	To Video	Connector
		To [VIDEO OUTPUT]		OR
	VIDEO				(not supplied)	Input Connector
	L	To [AUDIO OUTPUT]			Audio Cable
	AUDIO				(supplied)
	R
	OUTPUT				To Audio Input Connectors
			Component Video Cable (not supplied)
		To [COMPONENT			To Component Video Connectors

VIDEO OUTPUT]

HDMI Cable (not supplied)

To [HDMI OUT]

When your TV has only DVI input, you can use a commercially available HDMI to DVI conversion cable to connect between the VCR and your TV.

To [HDMI OUT]

HDMI to DVI conversion cable	To DVI
(commercially available, not
supplied)	connector

DIGITAL IN

R

AUDIO

L

VIDEO

NOTES:

•HDMI will be automatically activated (HDMI-ON) when a HDMI connection has been made. To de-activate (HDMI-OFF), press [HDMI] on the front panel and the [HDMI] LED will turn off.

During HDMI-ON ([HDMI] LED on), the image format output to the TV connected via the HDMI connector will be in accordance to

the image format of the TV. During HDMI-OFF ([HDMI] LED off), the image format output to the TV is in accordance to this VCR’s “IN/OUT FUNCTION” menu settings “TV OUTPUT 1” and “TV OUTPUT 2” (A page 65). If the picture cannot be properly displayed on the TV when using the HDMI to DVI connection, try setting HDMI to OFF.

If your TV is not High-Bandwidth Digital Content Protection (HDCP) compatible, the pictures will not be properly displayed on the TV. In this case, use the component video, s-video or video connection.

•If you cannot see the pictures on the TV screen when you play back a tape, set “TV OUTPUT 2” to the appropriate mode (A page 65). “TV OUTPUT 2” is invalid when HDMI is activated.

•To operate the VCR with your TV using the HDMI, DVI, Component Video or S-VIDEO connection, set your TV to the AV mode

using the TV’s Remote.

You can also use the TV/VCR button on the VCR’s Remote to set your TV to the AV mode (A page 76).

•To ensure that you can record one show while watching another (A page 38), you must also connect the VCR to the TV using the RF cable.

•Use the commercially available i.LINK cable (4-pin, S400, below 3m). If the cable used is above 3m, this VCR will not fully maximize its performance.

•For full identification of the VCR’s rear panel, refer to the Index (A page 8).