Gigabyte GA-M68MT-S2P Date mmddyy, Time hhmmss, IDE Channel 0, 1, 2, 3 Master, Halt On, Memory

Date (mm:dd:yy)

Sets the system date.

Time (hh:mm:ss)

Sets the system time.

IDE Channel 0, 1, 2, 3 Master

IDE HDD Auto-Detection, IDE Auto-Detection

Press <Enter> to autodetect the parameters of the SATA device on this channel. IDE Channel 0, 1 Master, Extended IDE Drive

Configure your SATA devices by using one of the three methods below:

• Auto	Lets the BIOS automatically detect SATA devices during the POST. (Default)
• None	If no SATA devices are used, set this item to None so the system will skip the
	detection of the device during the POST for faster system startup.
• Manual	Allows you to manually enter the specifications of the hard drive when the hard drive
	access mode is set to CHS. (For IDE Channel 0, 1 Master only.)
Access Mode	Sets the hard drive access mode. (Default: Auto)

The following fields display your hard drive specifications. If you wish to enter the parameters manually, refer to the information on the hard drive.

Capacity	Approximate capacity of the currently installed hard drive.
Cylinder	Number of cylinders.
Head	Number of heads.
Precomp	Write precompensation cylinder.
Landing Zone	Landing zone.
Sector	Number of sectors.

Halt On

Allows you to determine whether the system will stop for an error during the POST.

Options are: "All Errors," "No Errors," "All, But Keyboard" (default), "All, But Diskette," "All, But Disk/Key."

Memory

These fields are read-only and are determined by the BIOS POST.

BIOS Setup - 24 -